Where is valet switch on viper alarm




















The largest plug will definitely have wires plugged in. Then there will be smaller ones. One of the smaller ones will have blue plastic surrounding the plug. That is where the valet switch plugs in. If there is nothing plugged in then take a metal paper clip and touch it to both metal terminals inside the blue plastic plug.

The valet can be placed by the installer anywhere in the vehicle or no where. Some of the pictures show just the valet button or switch by itself. Note that some systems have a button and a switch and this usually indicates it is a remote start system where the toggle switch is used simply to turn remote start functionality on and off.

In those cases the button is the valet button also known as override button or programming button. Car owners need to let others operate their cars eventually. Valet parking, a mechanic at your local repair shop are examples of times when you want to have your car disarmed so you don't have to hand over the expensive remote, just the key. You wouldn't want to face the inconvenienbce if they lose or damage it. The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system.

To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. Put the key in the ignition and turn to the "on" position. Press down the valet button for five seconds. Check the LED light on your alarm system while continuing to press the button.

Turn the ignition off and remove the key once you set the valet mode. Enable Valet Mode A common location would be on the driver's kick panel cover, or on the side of the center console if the vehicle has one. Once this switch is located you will need to put your key into the ignition cylinder and turn it to the "ON" or "RUN" position.

Asked by: Tida Bonner automotive auto safety technologies What is the valet switch on car alarm? Last Updated: 13th July, The valet switch allows you to temporarily bypass all alarm functions , eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.

Louise Borns Professional. Where is the valet button on a remote starter? Typical locations for valet switch:. Under the driver's side dash mounted in the under-dash covering trim panel or wire-tied to a harness Mounted in the driver's side kick panel.

Mounted in the steering column plastic housing. Behind a fuse block door or access panel. Low in the center console in the back of a pocket.

Russ Hensele Professional. How do I reset my automatic car starter? How to Reset a Remote Starter. Enter your car with your starter and ignition key and leave the driver's door open. Insert your key into the ignition and turn it to the "On" position. Press and hold the "Valet" button on your remote and wait for the horn to chirp. How do I get my car out of valet mode? When you press these buttons, the parking lights should flash two times.

Press the Start button , and your car should be warm and toasty! Mozella Radu Explainer. Does a valet key have a chip? Yes the valet key has a chip in it that is coded to your immobilizer. Relay Diagrams. Subwoofer Wiring. Vehicle Wiring. Recent Topics. Site Search. Site Menu.

Advanced Search. Members Search Register Login. Joined: July 19, Location: Mississippi, United States.



0コメント

  • 1000 / 1000